How to Refill the Anti-odor Filter?

After 3 to 4 months of using your Tero device, the time has come to recharge the anti-odor filter to ensure a completely odor-free food waste processing cycle.

Here is a video showing how to recharge the anti-odor filter on the Tero device:

You can also refer to the following steps to recharge your anti-odor filter:

1. Reloading the cartridge

Step 1: Remove the ventilation plate from the cover. To do this, lift the rear part of the piece and pull toward you.

Step 2: Remove the anti-odor filter cartridge. Grasp it by the tabs and pull up.

Step 3: Remove the cartridge cover by first gently pulling the 6 tabs outward to dislodge the cover base.

Step 4: Take the two bags of granules and pour the entire content of the two bags into the cartridge, making sure to fill the container to the top and spread the granules evenly.
CAUTION - Pour the entire contents of the 2 bags of activated carbon granules into the cartridge so that it is fully filled, and the filter can neutralize as much odor as possible.

Step 5: Place the cartridge cover on the container.

Step 6: Gently pull up the expandable tabs until they press down on the lid so that it stays in place.
NOTE - Make sure that the cartridge is securely closed so that no carbon granule can escape from the container.

Step 7: Place the cartridge in its compartment in the lid of the device.

Step 8: Replace the ventilation plate on the cover of the device.
NOTE - First insert the hooks of the plate into the slots provided in the lid, then press the back of the plate to secure it to the lid. This ensures that the filter cartridge holds in place when opening the device.

2. Installing the dust filter

1. Remove the grid located in the cover of the device using the opening on the side.
   
2. Place the dust filter in the grid.
   
3. Replace the grid in the device cover by pressing hard on the two black snaps.

Once you have changed your carbon granule and filter, you must reset the counter by inserting a pointed object into the hole located behind the device. Hold the pointed object for 5 seconds. If the filter change indicator light is on on the front of your device, then you will see it turn off.